10-15-2003 02:43 AM - edited 03-02-2019 11:01 AM
Firstly, i spologize for everyone..
I know but i can't find where is board about this kind of question...:)
Now, I'm using Compaq Presario 2851AP.
Using this, I can't give Ctrl Break signal so never get Rom Monitor of router..
If anybody use Presario 2800 or something and know how, let me know that.
Thanks HJ
10-15-2003 04:59 AM
Try holding down the Function (Fn) key first and then doing a Ctrl Break
10-15-2003 08:59 PM
I know that.
And I did try below document...But I coundn't
http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml
Thanks
10-17-2003 04:22 AM
If you're using the version of Hyperterminal that came standard with the operating system, that might be your problem. Try upgrading to Hyperterminal Private Edition and see if that works.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide