duplicate ip address using redundant sup engine

[rpalacio]

hello,

We have 2 sup engine (sup eng2/msfc2) on our 6500. I noticed that the configuration on the switch is being automatically synchronized between the sup engine, but the msfc config doesnt.

we have done the configuration on the msfc by manualy duplicating, but resulted to prompting us "duplicate ip address".

Any suggestion on how it should be done?

thanks a lot.

[rfroom]

Review the section on MSFC redundancy in the following document:

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080207766.html