cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
205
Views
0
Helpful
3
Replies

EIGRP will not fail over

cro9uk
Beginner
Beginner

Can anyone help please. I have a 2611 and simply want the router to fail over to the backup DSL link when the primary fails. The problem is the primary is connected to a media converter which then connects to a point to point wireless access point. When the wireless goes down the media converter is still active so the router thinks the link is still alive and doesnt fail over. I have tried object tracking of the routing state will no luck, the only way i can get it to fail over is to physically pull out the RJ45.

3 Replies 3

a.kiprawih
Rising star
Rising star

Are you referring the object tracking of routing state to the dialer watch?

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800872ed.html

Rgds,

AK

jackyoung
Frequent Contributor
Frequent Contributor

Or if you use dynamic routing protocol and floating static to maintain the fallover. Once the route disappear, static will appear in routing table then use backup path.

Hope this helps.