Error in router

[fajarkusmelia]

I use cisco 3600 series router.Everytime i enter the router, it always shows the error message like this :

07:16:39 %AMDP2_FE-5-LATECOLL: FastEthernet1/0 transmit error

that error showed at time :07:16:39.

Does anyone can help what is this error?and how to solve it?

[Prashanth Krishnappa]

What connects to this port? Check for any speed/duplex mismatch issues. The following page should help as well

http://www.cisco.com/warp/public/63/eth_collisions.html#topic4

[fajarkusmelia]

interface FastEthernet1/0

ip address 10.6.7.130 255.255.255.0

ip nat outside

duplex auto

speed auto

its interface connect to other interface router with ip : 10.6.7.2

[spremkumar]

hi

can u manually set the duplex and speed on the both the faeths ??

just give show int faeth x/x on both the sides and do the changes accordingly..

regds

[Kevin Dorrell]

A "late collision" is a half-duplex procedure error that is someone else's fault. That is, I was playing half-duplex, I started transmitting a frame, and someone else interrupted me after the normal permitted window for collisions.

These are the three most likely reasons for this:

1. The router is connected to a hub (half-duplex), and there is something else on the hub that has been configured as full-duplex.

2. The router has been connected with a cross-cable to something that is playing full-duplex.

3. The router has been connected to a switchport that is forced configured full-duplex. (auto does not negotiate correctly against forced full duplex).

Kevin Dorrell

Luxembourg

Kevin Dorrell

Luxembourg