Hi,
I am trying to configure etherchannel between two linux servers and 3750 switch. Linux interfaces are bonded and can ping each other. Both are on same subnet. When I try to send traffic from one server to another I am getting throughput equal to 1 Gig and its never crossing it. Below is my switch config. Please advise if something need to be changed on switch.
interface Port-channel5
switchport access vlan 10
switchport mode access
!
interface Port-channel6
switchport access vlan 10
switchport mode access
!
interface GigabitEthernet1/0/1
switchport access vlan 10
switchport mode access
speed 1000
duplex full
channel-group 5 mode active
spanning-tree portfast
!
i
!
interface GigabitEthernet1/0/6
switchport access vlan 10
switchport mode access
speed 1000
duplex full
channel-group 5 mode active
spanning-tree portfast
!
!
i
!
interface GigabitEthernet1/0/17
switchport access vlan 10
switchport mode access
speed 1000
duplex full
channel-group 6 mode active
spanning-tree portfast
!
!
interface GigabitEthernet1/0/23
switchport access vlan 10
switchport mode access
speed 1000
duplex full
channel-group 6 mode active
spanning-tree portfast
!
Thanks in advance.
Meerz