Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have four 1200 series AP. Part number of these AP's is AIR-AP1231G-A-K9. I am thinking to buy a new 2504 WLC with 5 AP licenses. Just wondering whether my AP's are compatible with WLC or not. These AP's are in close proxomity and start contendi...
Hi all,1) I am new to MPLS and trying to configure a scenario in a non production environment. Is it possible to have L3 VPN's without using BGP in MPLS core network? For some reason I am more inclined to use RIPv2, EIGRP or OSPF in the core.2) Is it...
Hi,I am trying to configure etherchannel between two linux servers and 3750 switch. Linux interfaces are bonded and can ping each other. Both are on same subnet. When I try to send traffic from one server to another I am getting throughput equal to 1...
Hi,I up loaded a wrong IOS on my 3640 router and it is not showing ATM module in IOS. IOS installed is Version 12.3(19), RELEASE SOFTWARE (fc2). I have NM-1A-OC3MM module. Can someone tell me correct IOS. RegardsMeer
I have a 3640 router installed with NM-1A-OC3MM. I upgraded the IOS and the new one is (C3640-I-M), Version 12.3(19), RELEASE SOFTWARE (fc2).ATM interface is showing in IOS. Do I need a right IOS. If yes than which one.Regards
Hi,Thanks for your reply. This document says 1230 Series, AIR-LAP1231G. I think I can upgrade AIR-AP1231G-A-K9 to AIR-LAP1231G. Please correct me if I am wrong.RegardsMeerz
Slot 0: Sync/Async Port adapter, 8 ports Port adapter is analyzed Port adapter insertion time unknown EEPROM contents at hardware discovery: Hardware revision 1.0 Board revision C0 Serial number ...
Hi Satish,Thanks for your reply. I have one NM-1A-OC3MM and a ethernet card and few serial interfaces on one module. Below is sh version.cisco 3640 (R4700) processor (revision 0x00) with 49152K/16384K bytes of memory.Processor board ID 26735267R4700 ...
