11-24-2004 02:39 AM - edited 03-02-2019 08:10 PM
In ciscoworks i get a msg in th monitoring.
Utilization exceed it´s tresholds.
If i click on details is see the following
currentutilization 241 %
Because the maxspeed is automaticly set to 56000 Bits/Sec.
It is a 1Mb DSL line so how do i change this?
11-29-2004 01:03 AM
Hi,
use the
bandwith ...
command on the proper interface.
Just note it might also influence routing protocols using bandwith as a part of the metrics (EIRGP, e.g.).
Regards,
Milan
11-29-2004 01:37 AM
thanks,
But the problem is that it is a VIRTUAL interface.
Virtual-Access3 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 56 Kbit, DLY 100000 usec,
reliability 255/255, txload 224/255, rxload 71/255
I don´t know if this is working.
jef
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide