My fault for not providing enough information.
I am using two 1600's with 56k CSU/DSU cards in them. They are connected with a rollover cable, with one router controlling the switching and the switching.
OT: you told me to try and turn on the switching earlier and it worked =) So thanks for fixing that little problem.
I actually hace to separate, but related problems..
I accidentally bounded DLCI 20 to S1 on my second router. I want to remove it becuase I already have DLCI in use another the router on the other end. I don't know whether or not that would cause conflicts, but regaardless, I want to remove it more uniformity's sake.
Now my other problem is the fact that when I try and add a DLCI to a sub interface of that ill-bounded S1 I get an error. It will say that the line protocol is up, then a few seconds later it is taken back down. I have a feeling that this problem is caused by the conflicting DLCI on the parent Serial interface.
Now that I've confused the heck out of you, here is the config info for that router along with the show frame pvc.
CONFIGURATION
-------------
Building configuration...
Current configuration:
!
version 12.0
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname butler
!
enable password voyager
!
ip subnet-zero
!
!
!
interface Ethernet0
ip address 192.163.123.30 255.255.255.0
no ip directed-broadcast
!
interface Serial0
no ip address
no ip directed-broadcast
shutdown
no fair-queue
!
interface Serial1
no ip address
no ip directed-broadcast
encapsulation frame-relay
logging event subif-link-status
logging event dlci-status-change
!
interface Serial1.1 point-to-point
ip address 10.0.0.3 255.255.255.0
no ip directed-broadcast
frame-relay interface-dlci 30
!
router eigrp 202
network 192.163.123.0
!
ip classless
!
!
line con 0
exec-timeout 5 0
transport input none
line vty 0 4
password voyager
login
!
end
SHOW FRAME PVC
--------------
PVC Statistics for interface Serial1 (Frame Relay DTE)
DLCI = 20, DLCI USAGE = UNUSED, PVC STATUS = ACTIVE, INTERFACE = Serial1
input pkts 1271 output pkts 0 in bytes 90821
out bytes 0 dropped pkts 0 in FECN pkts 0
in BECN pkts 0 out FECN pkts 0 out BECN pkts 0
in DE pkts 0 out DE pkts 0
out bcast pkts 0 out bcast bytes 0 Num Pkts Switched 0
pvc create time 00:45:25, last time pvc status changed 00:45:25
DLCI = 30, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE = Serial1.1
input pkts 0 output pkts 3 in bytes 0
out bytes 843 dropped pkts 0 in FECN pkts 0
in BECN pkts 0 out FECN pkts 0 out BECN pkts 0
in DE pkts 0 out DE pkts 0
out bcast pkts 3 out bcast bytes 843
pvc create time 00:44:54, last time pvc status changed 00:44:44
**Note: I noticed when I pasted this into the window that the DLCI *is* removed from S1, but it's still in the PVC listing. **
But it still does not let me add a new DLCI mapping to the S1.1 interface.
Also for future reference is there any way to clear all configurations and start over as if the router just came outta the box?
Hope you can make some sense of this mess =)
--Mike
