07-18-2004 09:03 AM - edited 03-02-2019 05:08 PM
Hi,
After we upgraded the image in the primary superisory engine (Sup1A) of cat 6509 and made the secondary supervisory engine sync, we see the image in secondary sup flash as RTSYNC_<image name>.
The size of this is also very less (2MB, instead of 7MB).
I know that the image will be displayed in the secondary supervisory engine as BTSYNC. But what is this RTSYNC?
Regards,
Seetharaman.
Solved! Go to Solution.
07-18-2004 10:13 AM
Hi Seetharaman :
Supervisor Engine Synchronization may happen during two conditions :
Synchronizing the Run-Time Image with the Bootstring : This will re-name the image on standby supervisor engine with RTSYNC extention.
Synchronizing the Boot Images on the Active and Standby Supervisor Engines : This will re-name the image on standby supervisor engine with
BTSYNC.
Following examples will gives multiple scenario's :
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_3/confg_gd/redund.htm#wp1020358
Hope it helps.
regards
Parag M.
07-18-2004 10:13 AM
Hi Seetharaman :
Supervisor Engine Synchronization may happen during two conditions :
Synchronizing the Run-Time Image with the Bootstring : This will re-name the image on standby supervisor engine with RTSYNC extention.
Synchronizing the Boot Images on the Active and Standby Supervisor Engines : This will re-name the image on standby supervisor engine with
BTSYNC.
Following examples will gives multiple scenario's :
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_3/confg_gd/redund.htm#wp1020358
Hope it helps.
regards
Parag M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide