01-03-2002 04:23 AM - edited 03-01-2019 07:54 PM
Is there something special to do if i instal
a 1600 router with BRI S/T on a S0 bus.It works on a TNR (T0)but not on a S0 bus.
Thanks
01-09-2002 12:27 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
01-09-2002 05:36 PM
It should work on a 1600 series. What does your sh isdn stat look like? What exactly doesn't work? Do you have isdn subaddressing setup?
Josh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide