05-06-2004 12:44 AM - edited 03-02-2019 03:30 PM
I have an AS5300 with ISDN PRI connected. I need to enable dial-in to terminal line from ISDN. But I need to be able to direct calls received over above PRI to selected range of lines (tty's). How can I achieve this range selection?
05-06-2004 07:48 AM
Assuming you are talking about directing incoming modem/async calls to specific tty/modem lines, you can use modem pooling :
http://cco/en/US/tech/tk801/tk36/technologies_configuration_example09186a0080094898.shtml
A newer equivalent feature is RPM or Resource pooling.
Correct me if I did not understand your question.
~Zulfi
05-07-2004 03:51 AM
I think modem pooling could be a solution, even though I will need to use called number identification (originally I thought I could direct incoming calls by the interface they arrived through). Thanky you, anyway.
05-06-2004 07:55 AM
You can redirect analog calls to certain tty lines based on the DNIS number received during the call setup in ISDN q931 using "modem pooling".
Does your setup have users dialing into the PRI using different numbers? Please refer to the sample config below:
http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a0080094898.shtml
Thanks, Mak.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide