05-29-2003 07:27 AM - edited 03-02-2019 07:44 AM
HI all.
I use an ISDN cisco for dialing in ms win98 remote access client with chap
as authenticate.
All works correctly, i assign dinamically the ip to all clients that connect,
but the clients does not take the correct default route to my isdn router.
Why this? I have to specify a parameter on the router?
Thanks.
05-29-2003 07:32 AM
Are the IP addresses correctly being acquired by the PCs? What does an "ipconfig" command (in dos) reveal the default gateway to be on the PCs once the dialing is complete ? You can additionally use a "route print" to see the default route in the local routing table of the PC.
05-29-2003 08:17 AM
No special config required on the router. If the ip address is negotiated correctly, both router and client will install host route for eachother. So on client. the ip address and default gateway allocated will be the same ip for PPP connection.
On the router, "sh ip route" should show host route with 32 bit mask for the dialin cleint. Pl. Verify that.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide