MGX 8850

[moament]

HI all,

Please i need to know, how to see the status of E3 line or port of MGX 8850 and how to test the port with loop test, which commands i can use.

Thanks & best Regards

[smif101]

Well the first thing you need to do is to go to the card in question by using the command cc then after that you should be able to display the lines and the command for a loop is addlnloop

[smif101]

Well the first thing you need to do is to go to the card in quest but using the command cc then after that you should be able to display the lines and the command for a loop is addlnloop

[smif101]

Well the first thing you need to do is to go to the card in question but using the command cc then after that you should be able to display the lines and the command for a loop is addlnloop

[renubhat]

Hi,

In order to check the status of E3 line on MGX , u have to give the command " dspln -ds3 x.y " example dspln -ds3 1.1

and for the loop use command addlnloop.

Rgds,

Renu