09-08-2004 11:12 AM - edited 03-02-2019 06:19 PM
What is the SNMP OID that supports get/set of the port duplex on a catalyst 4506 running IOS Version 12.1(20)EW2 ? Also, is there an OID that allows the port speed to be set (including auto)?
09-08-2004 11:41 AM
dot3StatsDuplexStatus from the ETHERLIKE-MIB.
09-08-2004 12:52 PM
That is a read-only OID. How do I set the duplex (and speed)
09-08-2004 04:30 PM
Check out:
.1.3.6.1.4.1.9.5.1.4.1.1.10.
Integer Values can be:
1 half
2 full
3 disagree (when the port was auto and it can't agree with host)
4 auto
.1.3.6.1.4.1.9.5.1.4.1.1.9.
Integer Values are the number of b/s of the port or 1 for auto. e.g. 100MB would be '100000000'
HTH
Dan.
09-09-2004 05:07 AM
Those OIDs are portDuplex and portAdminSpeed from the portTable MIB. Unfortunately, they are not supported by IOS on the catalyst 4500's.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide