03-08-2004 12:18 PM - edited 03-02-2019 02:07 PM
Okay, so I need to be able to have a device plugged into my 4506 that will need to be referenced from two seperate IP addresses. I was led to believe that I could simply sub-interface this port and be done with it. However, the basic feature set doesn't support this. Anyone have any ideas on this? Is this even possible? If I can't do this - can I do it any other way within my 4506? I'm running Basic Layer3 12.1(20) by the way.
03-08-2004 08:08 PM
hi
I think There is no option assiginig to IP address..
if u want to assign single IP address pls go trgh this command
set int sc0 5 x.x.x.x 255.255.255.0.
bye
sat
03-08-2004 08:21 PM
hi
In earlier command i have given 5 pls ignore that
I think There is no option assiginig to IP address..
if u want to assign single IP address pls go trgh this command
set int sc0 x.x.x.x 255.255.255.0.
bye
sat
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide