Re: One port of 2950G attached to a hub is not forwarding,why?

cobra_he · ‎02-10-2003

Hello,in my network,a 2950G-24 switch is attached to a Hub,distance between them is near 100m,the connection port in 2950G-24 is configured to 10m and half -duplex.After a uncertain time,the port led is solid amber,status of the port is line down and protocol down.After re-plug out and in the cable,the port become ok.Why?can you tell me how to resolve this problem?Thanks.

Prashanth Krishnappa · ‎02-10-2003

Does the interface see lot of collisions? If so, the port might be error disabling. Can you paste the output of sh interface fastethernet 0/x

cobra_he · ‎02-24-2003

Following is the output on 2003/02/12 and 2003/02/24.

2003/02/12

FastEthernet0/26 is up, line protocol is up

Hardware is Fast Ethernet, address is 0009.b7ce.8e5a (bia 0009.b7ce.8e5a)

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive not set

Half-duplex, 10Mb/s

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output 00:00:01, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue :0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

25072 packets input, 5918241 bytes, 0 no buffer

Received 2620 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

155221 packets output, 30164967 bytes, 0 underruns

4 output errors, 1478 collisions, 3 interface resets

0 babbles, 0 late collision, 1136 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

cobra_he · ‎02-24-2003

Following is the output on 2003/02/24.

2003/02/24