07-21-2004 12:33 PM - edited 03-02-2019 05:13 PM
Good Day
I have a Router Cisco 805 and I trying to recover the lost password, but when
Press Break on the terminal keyboard within 60 seconds of the power-up to put the router into ROMMON
appear this and i don't know what i have to do:
TinyROM version 1.4(1)
19:38 11/07/00
Copyright (c) 1998-2000 by cisco Systems, Inc.
Copyright (c) 1998-2000 by cisco Systems, Inc.
POST ............ OK. 8MB DRAM, 4MB Flash.
boot> set
set baud =9600
set data-bits =8
set parity =none
set stop-bits =1
set console-flags =0
set mac-address =00B0.C28C.B05C
set unit-ip =0.0.0.0
set serv-ip =0.0.0.0
set netmask =0.0.0.0
set gate-ip =0.0.0.0
set pkt-timeout =4
set tftp-timeout =16
set boot-action =flash
set file-name =""
set watchdog =off
set prompt ="boot"
set ios-conf =0x2102
boot> set ios-conf = 142
ios-conf: failed, "permission denied"
boot>
?????????
Thank You very very much
07-21-2004 07:52 PM
Hi
u r trying with 142
try set ios-conf =0x2142 it shuld work fine with this ...
regds
prem
07-22-2004 08:25 AM
boot> set ios-conf =0x2142
ios-conf: failed, "permission denied"
07-22-2004 10:28 AM
08-02-2004 12:18 PM
Hola Hernan!
Trataste de colocar el parametro
"set ios-conf = 142", pero creo que esto solo funciona con el prompt "boot#" y no con el prompt "boot>"
Cuentanos como lo solucionaste tu problema.
Saludos,
Carolina
09-08-2004 06:08 AM
I solved the problem
thank guy gez
josrankin - Cisco Systems
Sep 7, 2004, 7:13am PST
You need to be at the boot# prompt, not the boot> prompt. To recover from the boot> prompt, do this:
boot> enable debug
password: em gubed
boot [DANGER] password
new:
again:
boot [DANGER] enable
boot#
Gracias Carolina por tu ayuda
09-08-2004 06:08 AM
I solved the problem
thank guy gez
josrankin - Cisco Systems
Sep 7, 2004, 7:13am PST
You need to be at the boot# prompt, not the boot> prompt. To recover from the boot> prompt, do this:
boot> enable debug
password: em gubed
boot [DANGER] password
new:
again:
boot [DANGER] enable
boot#
Gracias Carolina por tu ayuda
08-02-2004 12:26 PM
Hola Hernan
Otra cosa que puedo ver es que en el registro
set file-name =""
El debe ir a la flash y buscar una imagen y no tienes ninguna definida.
Saludos,
Carolina
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide