Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question on MPLS VPN Route Reflectors or most likely on the use of the "rr-group" command. Say you have 5 PE routers that have 2 seperate customers MPLS VPNS configured. These 5 PE routers are peering with a route reflector and you want them...
Can someone explain to me the technical differences between WPA key management and CCKM key management ? Is CCKM just pre-WPA standard and only works on Cisco cards or is there a difference ?I know CCKM supports fast reassociations but is that the on...
i am looking at deploying the following:Access points: Cisco 1200'sClient adapters: Aironet a/b/gAAA server: Cisco ACSAuthentication: LEAP (then EAP-FAST when out)Encryption: WPA TKIP (is MIC included in TKIP?)Management: ...
Correct me if I'm wrong, but would this be one of the higher grade security configs for wireless, without using Layer 3 VPN:Access Points: Cisco 1200 seriesWireless cards: Cisco Aironet a/b/g PCMCIAAAA Server: Cisco ACSEAP Authentication: LEAP (and t...
I am designing a wireless solution for a client and am looking for some valuable insite that this list might provide. The clients data infrastructure is all Cisco. Mostly 3500 series switches and 2600/3600 routers. I am looking at the 1200 series AP'...
First are you running IOS or CatOS on this switch ?When you perform a "show module" whats status does it say the L3 module is ? Have you rebooted the module ?
Almost all Cisco switches/routers can act as DHCP servers. They cannot act as DNS servers as they can only do DNS lookups for commands or addresses entered via the CLI. I would go with either a Sun Solaris box running BIND for DNS or an F5 Networks a...
The redundancy is transparent to the users, when configuring. As for when an MSFC or Supervisor module fails, it should take around 3 seconds (give or take) for the system to be operational.
I would go with a 3550. Pick which one provides the port density and physical interfaces you need.http://www.cisco.com/en/US/products/hw/switches/ps646/index.html.
