09-16-2004 09:49 AM - edited 03-02-2019 06:32 PM
Hi all,
I have CW DF sending email for a router .it is as follows
this email was sent sept15 at 6:22PM
InCharge Domain : DFM Active: Router True NY.abc.com PerformanceException - System is experiencing POrt or Interface performacne problems.
this email was sent sept15 at 6:26PM
InCharge Domain : DFM Clear: Router FalseNY.abc.com PerformanceException - System is experiencing POrt or Interface performacne problems.
sh interface
FastEthernet0/0 is up, line protocol is up
Hardware is AmdFE, address is
Internet address is x.x.x.x/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 01:53:15
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 396000 bits/sec, 90 packets/sec
5 minute output rate 58000 bits/sec, 65 packets/sec
668575 packets input, 334752982 bytes
Received 23558 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
527703 packets output, 62018381 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
ATM1/0 is up, line protocol is up
Hardware is RS8234 ATM DS3
Description: 5 Mbps
MTU 4470 bytes, sub MTU 4470, BW 5000 Kbit, DLY 190 usec,
reliability 255/255, txload 36/255, rxload 10/255
Encapsulation ATM, loopback not set
Encapsulation(s): AAL5
1023 maximum active VCs, 1 current VCCs
VC Auto Creation Disabled.
VC idle disconnect time: 300 seconds
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 01:50:21
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1
Queueing strategy: Per VC Queueing
30 second input rate 197000 bits/sec, 159 packets/sec
30 second output rate 714000 bits/sec, 149 packets/sec
942350 packets input, 155686189 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
878422 packets output, 381548396 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
ATM1/0.1 is up, line protocol is up
Hardware is RS8234 ATM DS3
Description: to PE
Internet address is x.x.x.x/x
MTU 4470 bytes, BW 45000 Kbit, DLY 190 usec,
reliability 255/255, txload 18/255, rxload 7/255
Encapsulation ATM
948640 packets input, 156775266 bytes
883975 packets output, 383514870 bytes
6696 OAM cells input, 6696 OAM cells output
AAL5 CRC errors : 0
AAL5 SAR Timeouts : 0
AAL5 Oversized SDUs : 0
AAL5 length violation : 0
AAL5 CPI Error : 0
Last clearing of "show interface" counters never
Qos is configured on this router.
Is it causing congestion on my interface..any help on this
thanks
09-27-2004 06:19 AM
You may verify your configuration for the QoS techniques with the documents given in the following location.
QOS CONGESTION MANAGEMENT
http://www.cisco.com/en/US/tech/tk543/tk544/tech_protocol_family_home.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide