cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
222
Views
0
Helpful
1
Replies

Performance Issue email sent thru CW DFM

goa0201
Level 1
Level 1

Hi all,

I have CW DF sending email for a router .it is as follows

this email was sent sept15 at 6:22PM

InCharge Domain : DFM Active: Router True NY.abc.com PerformanceException - System is experiencing POrt or Interface performacne problems.

this email was sent sept15 at 6:26PM

InCharge Domain : DFM Clear: Router FalseNY.abc.com PerformanceException - System is experiencing POrt or Interface performacne problems.

sh interface

FastEthernet0/0 is up, line protocol is up

Hardware is AmdFE, address is

Internet address is x.x.x.x/24

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 100Mb/s, 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 01:53:15

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 396000 bits/sec, 90 packets/sec

5 minute output rate 58000 bits/sec, 65 packets/sec

668575 packets input, 334752982 bytes

Received 23558 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog

0 input packets with dribble condition detected

527703 packets output, 62018381 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

ATM1/0 is up, line protocol is up

Hardware is RS8234 ATM DS3

Description: 5 Mbps

MTU 4470 bytes, sub MTU 4470, BW 5000 Kbit, DLY 190 usec,

reliability 255/255, txload 36/255, rxload 10/255

Encapsulation ATM, loopback not set

Encapsulation(s): AAL5

1023 maximum active VCs, 1 current VCCs

VC Auto Creation Disabled.

VC idle disconnect time: 300 seconds

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 01:50:21

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1

Queueing strategy: Per VC Queueing

30 second input rate 197000 bits/sec, 159 packets/sec

30 second output rate 714000 bits/sec, 149 packets/sec

942350 packets input, 155686189 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

878422 packets output, 381548396 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

ATM1/0.1 is up, line protocol is up

Hardware is RS8234 ATM DS3

Description: to PE

Internet address is x.x.x.x/x

MTU 4470 bytes, BW 45000 Kbit, DLY 190 usec,

reliability 255/255, txload 18/255, rxload 7/255

Encapsulation ATM

948640 packets input, 156775266 bytes

883975 packets output, 383514870 bytes

6696 OAM cells input, 6696 OAM cells output

AAL5 CRC errors : 0

AAL5 SAR Timeouts : 0

AAL5 Oversized SDUs : 0

AAL5 length violation : 0

AAL5 CPI Error : 0

Last clearing of "show interface" counters never

Qos is configured on this router.

Is it causing congestion on my interface..any help on this

thanks

1 Reply 1

irisrios
Level 6
Level 6

You may verify your configuration for the QoS techniques with the documents given in the following location.

QOS CONGESTION MANAGEMENT

http://www.cisco.com/en/US/tech/tk543/tk544/tech_protocol_family_home.html

Review Cisco Networking for a $25 gift card