show mac address table doesnt work

[bade11]

I gave the IP Adress, Gateway and Dns,  PC1 and PC2.After ping. But doesnt work show mac address table command.

[balaji.bandi]

Couple of basic questions to ask here :

Can you post the switch configuration :

what is the vPC'2 IP address range ? what is the VLAN 1 IP ?

[bade11]

PC2 IP and PC1 IP 

---

@balaji.bandi wrote:

Couple of basic questions to ask here :

Can you post the switch configuration :

what is the vPC'2 IP address range ? what is the VLAN 1 IP ?

---

[balaji.bandi]

Where is the switch config ?

[bade11]

---

@balaji.bandi wrote:

Where is the switch config ?

---

[balaji.bandi]

that is not the config

type show running (post the config to review)

[bade11]

---

@balaji.bandi wrote:

that is not the config

type show running (post the config to review)

---

[balaji.bandi]

Here is switch config and tested with vpc and you able to view all MAC address as soon as they resolve arp resolution.

interface Vlan1
ip address 192.168.50.1 255.255.255.0
no ip route-cache
!

Switch# show ip arp
Protocol Address Age (min) Hardware Addr Type Interface
Internet 192.168.50.1 - aabb.cc80.f000 ARPA Vlan1
Internet 192.168.50.10 1 0050.7966.6810 ARPA Vlan1
Internet 192.168.50.11 1 0050.7966.6816 ARPA Vlan1

Switch#show mac address-table
Mac Address Table
-------------------------------------------

Vlan Mac Address Type Ports
---- ----------- -------- -----
1 0050.7966.6810 DYNAMIC Et0/0
1 0050.7966.6816 DYNAMIC Et0/1
Total Mac Addresses for this criterion: 2

VPCS> show ip

NAME : VPCS[1]
IP/MASK : 192.168.50.10/24
GATEWAY : 192.168.50.1
DNS :
MAC : 00:50:79:66:68:10
LPORT : 20000
RHOST:PORT : 127.0.0.1:30000
MTU : 1500

VPCS> show ip

NAME : VPCS[1]
IP/MASK : 192.168.50.11/24
GATEWAY : 192.168.50.1
DNS :
MAC : 00:50:79:66:68:16
LPORT : 20000
RHOST:PORT : 127.0.0.1:30000
MTU : 1500