show top

[azmath.hk]

Hi folks,

I need to know the commands which shows utilization of ports in both i.e CATOS & IOS. However i have found sh int gig 1/1 stats but still we have to do it manual calculation on paper but i want the command if there is any..

Your support will be highly appreciated.

Regards,

Azmath Khan.

[Prashanth Krishnappa]

There is no command which gives you this in % in IOS. IOS does not support sh top either. There is an enhancement filed for it.

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCds01711

[Tsasbrink]

For ios some switches support

show controller utilisation

[azmath.hk]

Thanks for your information. Could you please tell me about CATOS & IOS has to be support in both....please advice