Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
308
Views
0
Helpful
1
Replies

Shut down and up Frame Relay sub-interface via SNMP

Go to solution
cloun81
Level 1
Level 1

‎06-09-2003 05:08 PM - edited ‎03-02-2019 08:00 AM

Does any body know how shut down and up Frame Relay sub-interface via SNMP?

Show me a sample, please.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
rmushtaq
Level 8
Level 8

‎06-09-2003 05:14 PM

If your sub-interfaces show up in the ifTable then you can snmpset on that particular interface using it's ifIndex via ifAdminStatus=2 (down) from the IF-MIB

View solution in original post

0 Helpful
1 Reply 1

Go to solution
rmushtaq
Level 8
Level 8

‎06-09-2003 05:14 PM

If your sub-interfaces show up in the ifTable then you can snmpset on that particular interface using it's ifIndex via ifAdminStatus=2 (down) from the IF-MIB

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card