02-16-2004 01:53 AM - edited 03-02-2019 01:36 PM
Hi,
Please advise any special configuration is needed for the simplex satellite link? And, the interface is HSSI.
Thanks!!
02-20-2004 07:49 AM
The special configuration required for simplex links are "no keepalive" and if it's receive simplex link then to give "transmit-interface xxx" command. Both are interface configuration commands.
05-08-2012 05:37 PM
where are we going to apply this command, at the transmit end or at the receive end?
Sent from Cisco Technical Support iPhone App
05-09-2012 01:29 AM
No keepalive goes on both ends.
Depending on applicaiton, you may not need transmit-interface at all.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide