cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
464
Views
4
Helpful
6
Replies

Support of 802.1x for Catalyst Swicthes

ravi.malghan
Level 1
Level 1

Hi: I have the following catalyst switches:

Catalyst 6500

Catalyst 4000

Catalyst 3560

Catalyst 3750

Is there any documentation in the form of a table that lists which of these support 802.1x and what are the IOS requirements?

Thanks

Ravi

6 Replies 6

Devang: for 6500 thatz exactly what I was looking for. But for 4500, 3560 and 3750 the pointers you provided are the actual steps to configure 802.1x. I am looking for something which says the minimum required IOS to be able to configure the 802.1x. The last 3 pointers have an IOS version for the title of document, but donot say that is the required level of IOS like the first pointer for 6500.

Thanks

Ravi

ravi...

use this link ...it will help you...

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

rate all helpfull posts

regards

Devang

Devang: this pointer is very helpful. One more question I have is the following:

I try to look for availability of "IEEE 802.1x - VLAN Assignment" for a 3560-I5-M. After I pick the feature and Platform, I see a number of realeases with different feature sets. What is this featureset? Shouldn't it just show one IOS or higher for a device.

Thanks in advance.

Ravi

I know the commands were first introduced on 12.1(19)EA1 for the 3560. I have a customer running 802.1x on their 3560 with no problems.

for 3750: 12.2(25)SEE1 12.2(25)SED1 12.2(25)SEC2 12.2(25)SEB4 12.2(25)SEA 12.2(25)SE 12.2(25)FZ

12.2(25)EZ1 12.2(20)SE4 12.1(19)EA1d

for 4500: 12.2(25)SG 12.2(25)EWA5

hope you will get from above...

rate all help full posts

regards

Devang

Review Cisco Networking for a $25 gift card