Buy or Renew
Buy or Renew
NOTICE: You can now engage in the community. Learn about the great new Cisco Umbrella content.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
419
Views
0
Helpful
1
Replies

Switch clusters and HSRP

s.ratliff
Level 1
Level 1

‎07-30-2003 02:25 PM - edited ‎03-02-2019 09:14 AM

Can the standby command switch ports be used as though they are ports on the other switches or are they of no use until it takes over as command switch. Also can I run HSRP between two 3550s that are not part of the cluster to provide two egress paths?

Labels:
0 Helpful
1 Reply 1

donewald
Level 6
Level 6

‎07-30-2003 06:28 PM

Yes, standby switch ports can be used if they are not the command switch. There function within the cluster has nothing really to do with switching functions. It's just for management. Also you can run HSRP between switches not in a cluster.

Hope this helps you,

Don

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card