Other Network Architecture Subjects

We wish to be able to inject a static route into the tables only when a specific interface is up. Otherwise we don't want to publish this information across the entire network.Our route maps havn't been working with the verify available, so does some...

Could anyone please point me to a link where I can download icons of Cisco products that I can use for my network diagram?thanks!

Does any body knows, which products (Router and Switch) can operate at 4000 m altitude?

Do you have somebody the packet flow documentation ?What happens when the packet is incoming to interface and outgoing from interface (routing, NAT, GRE, IPSec etc.)?ThanksMichal Dubec

Hi ciscoer,I've configured back-to-back point to point betwent 2600 and 3600. The max clock-rate I can used is 512000 using the serial-RS232-DCE/DTE. As Cisco stated the WIC-1T max speed is 2048. How to configure to support 2048MbThanks in advancedHA...

Currently I have r1 and r2 running HSRP connected to a /24 network. I am moving this network to multiple /31. Is there any way to keep HSRP configured between r1 and r2, yet, move them to a point-to-point link to ra and rb?Thanks! ra rbO () O |...

How do I remove sub interfaces on a router do I first need to remove the ip address what are the commands

I have an old 2501 router that I want to put back in service.When I do a sh ver the Configuration register is 0x42When I try to set the Configuration register to 0x2102 it just resets the router.Charlie in OhiO

What is the most recent IOS IP/ADSL (feature pack) for 1751-V router?

Does this look like it would work?class-map match-any voice match ip rtp 16383 16383 match access-group 101!!policy-map goodvoice class voice priority 96 class class-default fair-queue!nterface Serial0/0 description Point-to-Point to xxxxxxx...

I have a problem of issuing rsh (remote shell) commands to cisco router. I've already enabled rsh on the router and defined a previlaged user account. The command "ip rcmd-host ..." requires both local and remote usernames and I've specified a window...

What the diference between 8AM/16AM and 8AM-J/16AM-J,can 8AM-J/16AM-J be used in countries other than Japan & Singapore, such as in China?

Can the standby command switch ports be used as though they are ports on the other switches or are they of no use until it takes over as command switch. Also can I run HSRP between two 3550s that are not part of the cluster to provide two egress pat...