07-09-2006 06:43 PM - edited 03-03-2019 03:58 AM
Hi all
I need expert advice from all of you.
Please see that attchment for details.
Many thanks in advance
ATU
07-09-2006 10:01 PM
Hi!
Was it working fine before??? Can you paste the output of 'Show run int fa 0/13' here?? Is the server 'teamed'??
Regards,
AbhisheK
07-10-2006 12:01 AM
Hi AbhisheK
Thanks for the reply.
Yes It was OK until recently (~a week ago).
As requested:
SW032_C29L01A09#sh run interf fa0/13
Building configuration...
Current configuration : 99 bytes
!
interface FastEthernet0/13
switchport access vlan 2
no ip address
spanning-tree portfast
end
SW032_C29L01A09#
The server is not teamed.
Thanks & regards
07-09-2006 10:16 PM
HI Tutinco,
its not the probs with the switch, it could be the probs with the cable termination, juz re-terminate them either on the Information Outlet or on the jack panel end. also try changing the patch cord
hope this helps,
rate this post.
07-10-2006 12:04 AM
Hi
Thanks for the advice. I will check it all and let you know shortly.
Regards
07-09-2006 11:05 PM
Hi.
Few things need to be check
1) cable termination RJ45
2) check other end of cable/switch
3) check speed setting
4)
It looks like physical layer problem..
_Minu
07-10-2006 12:06 AM
Thanks Minu
I will check them all.
Regards
07-10-2006 12:24 AM
Hello,
you might want to try, as suggested previously, to set the switchport to:
duplex full
speed 100
and make sure that the settings on the server NIC match, that is, that the server NIC is not configured for auto-negotiation...
Regards,
GNT
07-10-2006 12:55 AM
Thanks GNT
I will try this.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide