- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-31-2005 10:10 AM - edited 03-02-2019 10:19 PM
Hello,
Which Cisco switches run CatOS and which run IOS?
Are there some that can run both CatOS and IOS?
Thanks,
John
Solved! Go to Solution.
- Labels:
-
Other Networking
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-31-2005 10:19 AM
Hi,
Cat6000 runs both CATOS and IOS. But need to make sure for running IOS which is also known as NATIVE IOS you must have MSFC on Supervisor oherwise with only sup is only capable of running CATOS.
Cst4000 runs CATOS with sup1 and sup2 but if you have 4232-L3 blade as one of the module you can have IOS on that but if you have sup2+,3,4,5 you will run IOS on that.
Catlyst 3750,3550,3660,2950,2900XL,3500XL runs IOS only.
Hope this helps.
Regards,
Ankur
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-31-2005 10:19 AM
Hi,
Cat6000 runs both CATOS and IOS. But need to make sure for running IOS which is also known as NATIVE IOS you must have MSFC on Supervisor oherwise with only sup is only capable of running CATOS.
Cst4000 runs CATOS with sup1 and sup2 but if you have 4232-L3 blade as one of the module you can have IOS on that but if you have sup2+,3,4,5 you will run IOS on that.
Catlyst 3750,3550,3660,2950,2900XL,3500XL runs IOS only.
Hope this helps.
Regards,
Ankur
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-31-2005 10:37 AM
Thanks Ankur,
It helps quite a bit.
John