11-26-2004 02:10 AM - edited 03-02-2019 08:13 PM
Hello all,
I'm getting the message hereunder each hour on a Cat4006:
%C4K_REDUNDANCY-5-CONFIGSYNC: The calendar has been successfully synchronized to the standby supervisor
Is there a way I can disable this?
Thanks in advance for your help.
Regards.
Alex
11-26-2004 04:12 AM
Try this link. You may find some answers there.
Configuring Supervisor Engine Redundancy using RPR and SSO
11-26-2004 05:10 AM
There is an enhancement request to rate limit this message. 12.2(25)EW will have it.
Take a look at
http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCsa39310
CSCsa39310
This is an enhancement request to make a knob ratelimitting below messages.
%C4K_REDUNDANCY-5-CONFIGSYNC: The calendar has been successfully synchronized to the standby supervisor
The messages are shown once a hour when redundant sup4s are configured with "ntp update-calendar".
L4507R-B#sh log
Oct 21 03:59:42.859 JST: %C4K_REDUNDANCY-5-CONFIGSYNC: The calendar has been successfully synchronized to the standby
supervisor
Oct 21 04:59:42.806 JST: %C4K_REDUNDANCY-5-CONFIGSYNC: The calendar has been successfully synchronized to the standby
supervisor
Oct 21 05:59:42.755 JST: %C4K_REDUNDANCY-5-CONFIGSYNC: The calendar has been successfully synchronized to the standby
supervisor
11-29-2004 03:18 PM
Hello Prashanth,
Thanks a lot for your answer. I tried to have a look to the bug description, but it seems to be confidential. Is there a reason?
Thanks in advance for your answer.
Alex
11-29-2004 05:09 PM
It was internally found during dev-test and hence not visible on CCO at this time. The details I included were the release notes for the bug.
11-30-2004 06:23 AM
Hello,
Thanks for the info.
Concerning the bug description, the switch is running with Sup2Plus (WS-X4013+) and the problem is also present on this kind of hardware.
Maybe the bug description should be updated.
Regards.
Rui
P.S.: My compliments for the professional way you work.
11-30-2004 06:36 AM
It is an IOS bug and affects all IOS based Supervisors for CAT4000.
I have changed the bug to be visible on CCO. It will be on CCO over the next 24-48 hrs at
http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCsa39310
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide