Other Network Architecture Subjects

Hello all,our two P2P serial links are configured as a single ppp multilink. I would like to add our bri interface to this multilink group but obtain an error '% Cannot put ddr interface in multilink-group'Can someone pls tell if applying the said c...

Is there any real advantage to using PAGP or LACP for etherchannel over hardcoding the channel to on other than they make bringing up etherchannels a little easier , is there a diagnostic advantage ? Same question for trunking setting them up...

Is the ip address and subnet mask of the managed devices stored somewhere in the ANI/RME database? If so, how can retrieve this by command line?I know we can use the 'cwexport config' command to extract the configuration, and in there find the correc...

Hi,I wasn't able to type in the line aux 0 in global configuration mode.Error message was:router(config)#line aux 0 ^% Invalid input detected at '^' marker.

My ISDN call is interrupting every 600 sec, although I have a traffic on interface BRI (I am pinging neighbour with 50000 packets)We experience problem with Cisco 3662, IOS 12.2(17a).debug isdn q931, q921, events don't show cause for call interrupt

I have PC's connected to VoIP phones where it is in connected to the switch. I believe I have all the ports configured correctly however, my VoIP phones on VLAN20 for instance cannot retrieve an IP from our DHCP server. The DHCP server is configure...

Hello all,I'm getting the message hereunder each hour on a Cat4006:%C4K_REDUNDANCY-5-CONFIGSYNC: The calendar has been successfully synchronized to the standby supervisorIs there a way I can disable this?Thanks in advance for your help.Regards.Alex

Hi,i'm trying to recover the pasword in my 2501 router.i've tried 0x2142 but failed.again i tried with 0x142 but still didn't work.when i'm issueing this commands it is rebooting automaticall,i maen i'm not issueing the reset command,its is rebooting...

We need to replace the server hardware for our current Cisco Works installation. Does anybody have procedures to move an installation with all the archives to a new server, instead of doing a fresh install and then just importing the devices with a c...

I am not able to boot a cisco switch 3550, when i reset the cisco switch with boot command than following messages are displayed:switch: bootLoading "flash:c3550-i9q3l2-mz.121-19.EA1c/c3550-i9q3l2-mz.121-19.EA1c.bin"...flash:c3550-i9q3l2-mz.121-19.EA...

I have a WS-C4506-S2+96 switch. in this switch can I replace a WS-X4013+ with a WS-X4232-L3?

On catalyst 2950 with c2950-i6q4l2-mz.121-22.EA1.bin we have command "rtr key-chain <name of key-chain>". But I can't find command "key chain <name of key-chain" for configuring password key-string for RTR/SAA authentication. So, how can I uses RTR/S...

Dear allas titled?Thanksmak

"IOS (tm) MSFC Software (C6MSFC-JSV-M), Version 12.1(8b)E15, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)"Hei,How do I make Vlan that that is just open for dedicated ports and ip add.microsoft and Mcafee.Thanks,TrondE

Hi all,I want to force serial interface to down when reliability falls below 95% , Iam able to achieve this by:PPP quality 95but problem is that line Protocol is forced to DOWN only at one side.Other side still line protocol shows up and so routing p...