10-23-2019 12:09 PM
I've tried searching google and haven't found anything. What is the transfer output trying to tell me with a ! or a . ?
Receiving asa-fp1k.9.13.1.SPA from 10.1.1.1!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!.!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.....!.!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Did I lose some packets? It's UDP, how would it know?
Solved! Go to Solution.
10-23-2019 03:15 PM
I'm unsure it's documented somewhere, but as far as I know meaning of '!' is "OK", and '.' mean "block lost"
It's UDP, how would it know?
It's not UDP, it's TFTP. Read RFC 1350 - The TFTP Protocol (Revision 2) to learn how TFTP protocol is designed.
10-23-2019 03:15 PM
I'm unsure it's documented somewhere, but as far as I know meaning of '!' is "OK", and '.' mean "block lost"
It's UDP, how would it know?
It's not UDP, it's TFTP. Read RFC 1350 - The TFTP Protocol (Revision 2) to learn how TFTP protocol is designed.
11-05-2019 09:26 AM
I suppose if I would have just read the tftp rfc right away, I maybe could have found that.
I new tftp used UDP but assumed because it uses UDP, it didn't use acknowledgements.
Thanks
10-24-2019 08:13 AM
10-25-2019 02:49 AM
Hello,
on a side note, according to the document below:
--> The exclamation point "!" indicates that the copy process is in progress. Each exclamation point indicates that ten packets have transferred successfully.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide