05-21-2003 11:56 PM - edited 03-02-2019 07:33 AM
Hi all,
I have a router on stick with Cisco 2551XM & Catalyst 2950-SI to manage 2 Class C networks (192.168.1.x/24 & 192.168.2.x/24).
Cisco 2651XM
|
Catalyst 2950 --- VLAN1 switch 192.168.1.x/24 (Catalyst 3550-SMI)
|
VLAN2 switch 192.168.2.x/24 (Catalyst 2950), -> not managed by me.
I want to limit certain users access to internet in 192.168.1.x, and no restriction to 192.168.2.x/24.
1. Can Catalyst2950-SI to perform this, instead of router (applying on trunk interface)? I want to avoid any effects 192.168.2.x users.
2. How about applying traffic shaping in per port basis, instead of ACL based ?
It seems that many QoS features are not available for Standard Image model.
Any ideas and helps will be greatly appreciated. Thank you.
Best regards,
b.go
05-25-2003 09:33 PM
Correct - SI image won't cut it. Upgrade to EI OR Perhaps -
one of - (a) use second ethernet interface in 2651XM to the switch.
Or (b) Try GTS on subinterface (not sure if that will work or not)
06-05-2003 03:38 AM
Hi, thanks for the reply. Yes I have applied/added the traffic shape for the sub interface. So how do I know if the traffic shaping is taking effect or not (for group 10 in this case). Below is the config for the output to internet interface.
interface Serial0/0
ip address ISP_ADD ISP_MASK
ip access-group 100 in
ip nat outside
encapsulation ppp
traffic-shape group 10 64000 8000 8000 1000
group 10 is the LAN that I want to control and group 100 is access for all LANs (including group 10 itself).
Many thanks for the ideas, and suggestions.
Best regards,
b.go
06-06-2003 10:53 PM
hi summons
u can chek the traffic-shape is not happening or not by issuing
ROUTER#sho traffic-shape statistics
Access Queue Packets Bytes Packets Bytes Shaping
I/F List Depth Delayed Delayed Active
Se3/0 152 0 17871 1766254 761 79122 yes
hope this helps ...
regds
prem
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide