09-06-2004 11:30 PM - edited 03-02-2019 06:16 PM
We have Catalyst WS-C2950-24. It works like normal.
But, if we connect new equipment on FastEthernet port,
there is a following message:
00:01:00: ERROR in strata_protected_notify:line935: can't get remote inst pointer
That it could be and how of it to get rid?
Best regards,
Alexey
09-07-2004 04:36 AM
Is this a new switch? It almost sounds as if it may have those ports setup as protected ports in Private VLANS
09-07-2004 05:06 AM
Yes, it new.
But, any Private VLANS does not exist
Switch#sh vlan private-vlan
Primary Secondary Type Ports
------- --------- ----------------- ------------------------------------------
Switch#
09-07-2004 05:39 AM
It appears that the code could be corrupt (the error is a pointer to an errored line of code: 935). It can't fetch a pointer to a remote instruction.
Aside from a management IP address, what other config have you added? What is the "new equipment?" Could the new equipment be putting out unknown (to Cisco) protocol information?
If the switch is still a basic configuration, try re-loading the IOS.
If that doesn't correct the problem, RMA or get a replacement for the switch.
FWIW
Scott
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide