09-01-2004 03:19 AM - edited 03-02-2019 06:10 PM
i am wanting to setup my servers in their own VLAN. config:
hosts: 10.1.x.x
snm: 255.255.0.0
gw: 10.1.0.1
i want to take my servers (10.1.30.x) and put in their own vlan.
all hosts (10.1.x.x) must be able to access the servers in this vlan.
any help is appreciated
09-01-2004 03:48 AM
Hello,
you will need a Layer 3 device in order to facilitate the inter-VLAN routing on. Which platform do you want to configure this on ?
Regards,
GP
09-01-2004 04:02 AM
6509...
09-01-2004 04:12 AM
This is how our 6509 MSFC is configured. All our servers are in the Servernet and other hosts are in various VLANS including the Client 1 shown below the Server VLAN.
interface Vlan113
description ServerNet
ip address 207.129.102.253 255.255.255.0
no ip redirects
mls rp vtp-domain xxx
mls rp ip
standby 1 priority 250 preempt
standby 1 ip 207.129.102.254
!
interface Vlan114
description Client 1
ip address 10.96.12.253 255.255.255.0
no ip redirects
mls rp vtp-domain xxx
mls rp ip
standby 1 priority 200 preempt
standby 1 ip 10.96.12.254
The 6509 switch itself is configured as follows:-
set vlan 113 name Server type ethernet mtu 1500 said 100113 state active
set vlan 114 name Client-1 type ethernet mtu 1500 said 100114 state active
Hope that's of some help.
Pete
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide