Other Network Architecture Subjects

Dear Forum Member,One of my customer ask me about how to provide ip address at switch ports. So if someone try to access the network using one of the switch ports, he will get the ip adddress from it, and not from dhcp server anymore. It more better ...

I want to use the feature of private VLAN , but 5.3 can't support that feature,so I want to update the CATOS, but as I know, the catos 5.4 or later can not run with the boorrom ROMMON ,5.1, when I show version as follow, display that the boorstrap is...

Hi,I currently have a flat L2 network of mostly 3548 switches connected with fibre to a 6509. Ip addressing scheme is 10.2.x.x/16. Because this net has grown there are now too many devices and performance is suffering. Also there is little redundancy...

Does anyone know if when you select the option "write running to startup" in Netconfig, does this occur before or after the job runs?Thanks.

i am wanting to setup my servers in their own VLAN. config:hosts: 10.1.x.xsnm: 255.255.0.0gw: 10.1.0.1i want to take my servers (10.1.30.x) and put in their own vlan.all hosts (10.1.x.x) must be able to access the servers in this vlan.any help...

we recently had 2 msfc's installed in our 6509. ivr was not setup as we had to put it on hold.i want to now enable it and begin setting up multiple vlans.any help is appreciated

Stupid question, but can someone point to me a doc on netbeui. I'm sure its not a routable protocol but need to be sure

I have an issue on (2) 3550's that I am configuring for L3. When I issue the 'ip routing' command the switch stops responding. I have to power off the switch and recover. I cannot get the switches to accept this command. They are 3550-48-SMI (121...

Hi,Is there any free downloadable TACACS+ server available?Sai.

Hi all, I want to block few users complete internet access and allow them to access only two web sites but we only have one complete subnet for all users.10.x.x.0/24. How will I be able to do it.We already have this access-lists implemented.---------...

Hi All, i am getting error mesg on my NRAS following is error mesg.Error 619 port disconnectedcan anybody tell me regarding this error mesg.Rgds,Ciscobuddy

Hi all, I appear to be having trouble with inter vlan routing.I have a 2900 edge switch who's ports are assigned to different Vlan's as required. this is connected to a 4500.We already have three vlans all working fine, but I have tried to set up ano...

(nevermind - fixed it)

Solaris 2.8Campus Manager 3.3 IDU 8.0sho cdp ne on the router sees several switches but these ar not appearing in Campus Manager after the deault 2hr discovery polling cyclePerhaps the lineDiscovery.router=offin/opt/CSCOpx/campus/etc/cwsi/ANIServer.p...

I am trying to Multi-Home a customer using only NAT and static routing. The customer is two small to get their own IP space, and this is just the way they would like this done. They have no servers that need reachability from the Internet......the ...