Would like to check if this IOS supports IPSEC software

[ahpark78]

Hi Gurus,

Would like to check the IOS Below if can support IPSEC implementation.

I have checked on the config t --command,but didn;t find any IPSEC.

WOUld like to confirm if tis IOS supports,if not, can i do an upgrade to diff IOS?

---------------------------------------

Cisco IOS Software, C1700 Software (C1700-K9O3SY7-M), Version 12.3(8)T3, RELEASE SOFTWARE (fc1)

---------------------------------------

thanks !

ken

[desai.jaideep]

Hi

Since you do not have a CCO login, there is little you or I can do ....but which router was that which is having a K9 IOS.....You can download the IOS from there and upload it to your current router.

Morever remember that you need at least 96Mb of RAM for running a IPSec IOS(You have 64).

Hope this helps.

Pls rate helpfull posts.

Regards

JD

[ahpark78]

Thanks Desai..I have checked that the DRAM is 64mb on the tools. Is that a minimum ?

Well, is that any links that I can download the IOS?

Will start to rate post soon..Thanks for all your contribution guys!

[desai.jaideep · Accepted solution]

Hi

IOS is not available freely over net as its a properity software and subject to legal actions.

If you have another router purchased by you yourself, then you can download it from there.Otherwise, you need to have a valid CCO login from which you can download the software for free.

You can ask your hardware supplier regarding the same.I am sure he will be able to help you.

Regards

JD

[ahpark78]

okay..thanks!

I have written an email to my hardware vendor..

Time to rate post!

thanks again for all your contribution, guys!

ken