Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,Anyone face this problem before? I have few printers, on certain time it wont be able to print/ping although it is on ready mode.Have checked the arp table on the switch but there isn;t any until unplug the network cable that connected to ...
Hi Experts,Can I know if the EIGRP will suddenly loses all of the neighbors for the updates??Any cause of this that can make this happens?Thanks in advanced.
Hi,Anyone knows what is the policy route map below means..I am confused..Thanks in advanced!----------------------------------------interface FastEthernet0/0.1 encapsulation dot1Q 1 native ip address 122.1.x.x.255.255.0 no ip redirects ip accounting ...
Hi,Would like to check will crypto VPN just broken like tat although config is correct? I have a traffic which cannot be encrypted..the VPN module is fine..TIA
Hi, Just wanna confirm here..Lets say if i have a Serial and Backup ISDN with route of 172.16.0.0 255.255.255.0 192.168.0.2172.16.0.0 255.255.255.0 Dialer 1 10Can I add another route of 172.16.0.0 255.255.255.0 192.168.1.2 100 As my objective is to p...
Hi Ciscobuddy,Are you referring to security hardening for the cisco switch and router ?Ken,http://www.merlionrewards.com/network-address-translation.html
Yeah, Salil got the point there.The config should not have contain conduits. It always good to test from the basic configuration like what Salil suggested.Ken,http://pixfirewallnotes.blogspot.com
I have checked on the printer and set the sleepy mode to 4hours..but doesnt seems able to ping although it is on Ready Mode.check the arp table, it was not there..by the way,how can i set the static entry on the switch?thanks.
