Other Network Architecture Subjects

Hello,I am preparing for the BCMSN exam, and am refering to the official cisco courseware v2.2.In Module 6, (6-88 through 6-90) there is a section on HSRP and stacked switches, with the suggestion that you implement a loopback cable between stacked s...

Hi,In 3560 24 port PoE switch status is showing as amber and i given the sh env all command in the swiych i got the following output. Please help me to resolve the issue.The ouput as follows.3560#sh env allFAN is FAULTYTEMPERATURE is FAULTYPOWER is O...

dear sir, we have 1 server with have fixed ip and virtual ip configured. fixed ip shown ok with connected link but virtual ip got problems ? any idea?

how do i add route in switch 3650 ?gv commands & mode

dear all,Is it possible that anybody from remote site configuring my router and i can know what is he configuring? what commands he is tryingRegards!!Mahesh

Hi Gurus,I have a problem here. Currently my router having an empty network module slot. But my company doesn't have budget to get a Network Modules with 4 BRIs Port or diff mixtures of interfaces.So, is that any network modules that support only 1 B...

Hi:Just need an advice on how to configure VLANs,InterVLAN routing and make Windows 2000 DHCP Server to work also for Stack C3750G-24TS Layer3 Switch..Thanks in advanceCliff

HelloI recently carried out some sniffing on a 3550 and noticed a lot of traffic that I should not have seen on that port. Having had a look around on cco this appears to be a known issue (unicast flooding) I am a little confused as to exactly what ...

Hi,I'm having this error when i boot my 2811 router:System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1)Copyright (c) 2005 by cisco Systems, Inc. Initializing memory for ECC. Bad RAM at location 0xA00000E0: wrote 0xA00000E0, read 0...

Hi,I'm having MLS 6509 with Sup2/MSFC2 and running either 12.1(23)E1 and 12.1(26)E1.IF i do sup swap using "reducancy force switchover" all line card interface goes down and even ospf also goes down and then come back and that create outage for me. C...

here is the command on my switch set spantree portcost 3/1-48 3019after reboot have noticed many times.. the value changes to someother random value.. Can any one explain whats the reason behind this..Thanks.Mahesh.