Two Questions....In the readme file at step 5 the command is tar xvf CSIDS-313-eng.tar. Is the command typed wrong because the file name does not match the file name in the previous steps.When I do the command tar xvf CSIDS-323-engrel2.tar.Z I recei...
I have noticed that the IDSM Module for the Cat6000 has not received an update since 30 MAY 02 with version IDSM-sp-3.0-4-S20. The other IDS Appliance line receives considerably more updates by comparison. When can we expect an update?
I have recently been examining my firewall log files and have noticed tons of port scans that the IDS has failed to pick up. Occassionally, the scans have been going on for hours across my entire IP block. What is going on with the scanner? Do I n...
Hi,i have a Cisco 1720 with an empty wic slot. I have to install a single port ethernet WIC to connect two lans. The current IOS version is 12.0(7)T and the memory features are: 12288/4096 DRAM and 4Mb Flash. I would like to know which is the most ap...
I recently installed a 4210 sensor behind our PIX 515 Firewall and it seems to be talking to the CSPM perfectly. I am a real security beginner so I had a difficult time deciding whether to install in front of or behind the firewall. We have a simple ...
I do not see signature 3705 listed on the NSDB when I go to the main signature list at the following link.https://172.19.X.X/protected/nsdb/html/all_sigs_index.htmlIs it missing from the NSDB?
Hi all,I have "3Com 3C920 Integrated Fast Ethernet Controller" installed on my laptop running windows 2000.After installing CISCO VPN V3.5 I see on more device named "3Com 3C920 Integrated Fast Ethernet Controller - Deterministic Network Enhancer Min...
There seems to be many articles for mail access but I have still a problem.Exchange 5.5 server is located behind PIX525 ver 6.1 and outside users need to access the exchange server with Outlook from outside.TCP 135, 139 are opened for exchange server...
pix 506 ios 5.2(6). after write erase and reload, the only thing i do is set a new ip-address on the outside interface. then i run a portscan (with haktek or gfi languard) and the ports 110 and 25 are open. where is my mistake?thxaxel
I am running PIX OS 5.2(3) and I am using conduit command not the ACL,If I upgrade PIX to 6.1.2 and Install PDM 1.1.2 and use PDM to configure PIX in future, Is PDM will use conduit or ACL? Do I need to convert conduit statment to Access control list...
I want to use the EzVPN in Client Mode to connect to the VPN 3005 Concentrator. In the documentation:The local router uses the DHCP protocol to assign IP addresses to the PCs that are connected to the router's LAN interface. This requires creating a ...
