Clear Access-List hitcnt

scottholwerda · ‎12-19-2003

I think I am overlooking the answear. What is the command to reset the hitcnt to 0 on an access-list on a Pix firewall to get a point of reference?

We have a 520 Pix.

mike-greene · ‎12-19-2003

Go into config mode and try this...

clear access-list count

Hope that helps.

scottholwerda · ‎12-19-2003

That is what I thought it was, but our PIX does not reconize that command. I made sure I was in configuration mode when I typed it. We have IOS version 6.0(1) if that makes a difference.

mike-greene · ‎12-19-2003

Does not look like it was released fully with no bugs until 6.2(1)

koaps · ‎12-19-2003

If it's critical to you to know the counts and you need them cleared you can try reloaded the pix(restarting) but this will take it down for a few min while it boots.

scottholwerda · ‎12-19-2003

I ended up creating a duplicate access-list and reassociating it with the interface.