06-07-2005 02:13 AM - edited 03-09-2019 11:30 AM
HI All
I have a PIX firewall and i have configure the outside and inside interface, unfortunely the customer only Public IP address has been used on the outside interface. how am i suppose to do NAT for my inside to get out to the internet?
06-07-2005 03:03 AM
Hi,
You can PAT your inside networks to your outside interface address.
The following example assumes you internal network is 10.10.10.0 /24:
nat (inside) 1 10.10.10.0 255.255.255.0
global (outside) 1 interface
HTH
Paddy
06-07-2005 04:31 PM
Thank for your reply pal! I will try it out.
06-07-2005 10:33 PM
You might also want to take a peep at this thread: http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Career%20Certifications&topic=Certifications&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd8588a.
And a few quick notes on configuring NAT: http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml.
Cheers,
Josef.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide