Hi all,
I have configured a cisco ASR1K for CGNAT and it only works for UDP traffic, is there any specific config that needs to be made to have TCP work for CGNAT ?
Config:
CGNAT#show run interface gigabitEthernet 0/1/0.220
Building configuration...
Current configuration : 122 bytes
!
interface GigabitEthernet0/1/0.220
encapsulation dot1Q 220
ip address 172.16.20.254 255.255.255.0
ip nat inside
end
CGNAT#show run interface gigabitEthernet 0/1/0.162
Building configuration...
Current configuration : 122 bytes
!
interface GigabitEthernet0/1/0.162
encapsulation dot1Q 162
ip address 172.16.2.140 255.255.255.0
ip nat outside
end
ip nat settings mode cgn
no ip nat settings support mapping outside
ip nat log translations flow-export v9 udp destination 172.16.20.142 59999 source GigabitEthernet0
ip nat translation timeout never
ip nat translation tcp-timeout never
ip nat pool CGNAT 172.16.2.140 172.16.2.140 netmask 255.255.255.0
ip nat inside source list 2 pool CGNAT overload
Thanks