DCM MK1 scrambling

[Hele Du]

Hello everybody.

I have two GBE cards and one co-process card in one MK1 chassis.

I want use port1-port2 outputing services and port3-port4 inputing services on both GBE cards.

I only have one coprocess card attached to second GBE card.

Is the outputing TS scrambling normally on first GBE card or it cannot scarmbling?

[rsantoso · Accepted solution]

There is no restriction to place GBE card with coprocessor card to be place in certain slot. So this is possible to place the GBE card with coprocessor into slot 1. However, to have the scrambling capability, the service output need to be map to the GBE card where the coprocessor attach to.

[kusridha · Accepted solution]

To clarify a bit further, the I/O card (GbE or ASI) you want to use for scrambling can be in any slot. However, all services that need to be scrambled have to be passed to an output port on this card.