Hi,
I configured LFI and I am not sure what the interface virtual-template 101 ip address should be ?
CCO documents usually use a ip unnumbered ethernet for the virtual-template.
In this scenario, a LAN interface is not available.
The config below works though:
interface Serial0/0/1.1 point-to-point
bandwidth 384
ip address 10.10.111.1 255.255.255.0
ip ospf mtu-ignore
snmp trap link-status
frame-relay interface-dlci 201 ppp Virtual-Template101
class frts-384
interface Virtual-Template101
bandwidth 384
ip address 10.10.111.1 255.255.255.0 <-------------- what ip address should be configured here ?
ppp multilink
ppp multilink interleave
ppp multilink fragment delay 10
service-policy output hq
!
Any help appreciated.
Thank you.
Paul