Dear Mrs and Ms,
I am configuring a 1832i in "Mobility Access Mode" for the first time.
I followed the "Cisco Mobility Express Deployment Guide" but, if I can ping the AP, I can't reach the "controller mode" in SSH and I can't reach the HTTPS GUI.
The only way to configure SSIDS and other paramteres is the console port.
On console port, the prompt is : (Cisco Controller) >
On SSH terminal, the prompt is : AP501C.B0B2.5650# (with capwap ap commands)
On HTTPS, there is no answer...
What configuration I had forgotten to enable "HTTPS" ?
Thanks a lot for your answers