I'm having problem with ASA 5510 and WLC 526, in this case the ASA provides DHCP, I created 3 vlan's (12 administrative, 13 visits, 10 AP's). WLC 526 has two network interface, eth0 in this vlan 10, and eth1 is in a TRUNK port on the switch in valn 12 and 13. The fact is that when a user attempts to connect to wireless network does not take DHCP, but setting a fixed ip connection works perfectly.
One problem is that the WLC has 526 limited-config below.
These commands available:
(Cisco Controller)> config?
Advanced Advanced Configuration.
(Cisco Controller)> config advanced?
802.11a 802.11a parameters.
802.11b 802.11b parameters.
Auto client-handoff handoff clients on the excessive retires.
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...
WLAN controller newb here. A power outage took out my home network but upon return my two SSIDs came back and my three APs went blue... everything WiFi related was working as expected. Sometime later I logged into the WLAN Controller web-page to see I hav...