Hello Guys,
I have configued two T1 dsu/csu card on two Ciso 3640.Back-to-back for my lab. I used RJ45 crossover cable between them. Both cards are in alarm(AL) what protocol or permeter that I am missing to make both routers talk to each other? See beloow and advised.
Router1
serial 2/0
ip address 10.10.11.2 255.255.255.0
service-module t1 clock source line
service-module t1 data-coding normal
service-module t1 timeslots all speed 64
service-module t1 framing esf
service-module t1 lbo none
service-module t1 linecode b8zs
no service-module t1 remote-alarm-enable
no service-module t1 fdl
encapsulation frame-relay
frame-relay lmi-type cisco
frame-relay interface-dlci 105
Router2
Router1
serial 2/0
ip address 10.10.11.1 255.255.255.0
service-module t1 clock source internal
service-module t1 data-coding normal
service-module t1 timeslots all speed 64
service-module t1 framing esf
service-module t1 lbo none
service-module t1 linecode b8zs
no service-module t1 remote-alarm-enable
no service-module t1 fdl
encapsulation frame-relay
frame-relay lmi-type cisco
frame-relay interface-dlci 501
Thx,
Eric
