Hi Guys,
Have an ASR1006 (Dual RP's/Dual ESP's), and the "standby" RP is stuck in rommon:
System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2008 by cisco Systems, Inc.
Current image running: Boot ROM0
Last reset cause: LocalSoft
ASR1000-RP1 platform with 4194303 Kbytes of main memory
no valid BOOT image found
Final autoboot attempt from default boot device...
media drive bootflash: not present
boot: cannot determine first file name on device "bootflash:"
autoboot: boot failed, restarting...
System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2008 by cisco Systems, Inc.
Current image running: Boot ROM0
Then checking dev, bootflash is there, but then cant be read:
rommon 1 > dev
Devices in device table:
id name
bootflash: Internal flash drive
harddisk: Internal hard disk
usb0: External USB drive 0
usb1: External USB drive 1
rommon 2 > dir bootflash:
media drive bootflash: not present
Any suggestions greatly appreciated.
