Hi,
I am using Prime Infrastructure 1.2 eval version.(100 devices and 150 interfaces limit)
I was hoping to send netflow data from Nexus 7010 and 3750X to PI.
So I add them manually and set up configuration for netflow.
After that, I can't see anything about netflow in [Operate]->[Performance]->[Service Assurance]
It shows no data available.
I look up in the user guide to figure out the problem.
Then I use [Configuration Templates] to deploy netflow config again.
The result is the same.
Can anyone with experience using netflow function in PI 1.2 could tell me where did I miss?
Thanks in advanced.
